For optimal high voltage conduction, the Mazda B2600 NGK ignition wire set ZE 17 will provide you that efficiency. This is part of your vehicle’s ignition system that harnesses the high voltage to the spark plugs. These sets of wires are designed to carry 20,000 to 50,000 volts, which is enough to throw you off the room if you are exposed to it. Their prime job is to handle that enormous power created by the ignition system to the spark plug without any restrictions. They are placed from the distributor cap to the spark plugs in the correct firing order. Every spark plug is required to only fire at the end of the compression stroke. Every cylinder has a compression stroke at a different time so it is a must for individual ignition wire to be directed to the right cylinder. The Mazda B2600 NGK ignition wire set is made to have a fairly thick insulation as well as its individual wires and has a very thin conductor placed at the center. But due to heat, the insulation may harden and eventually cracks may develop, making it brittle and later on will break down. This resulting break down may cause the high voltage to be directed anywhere in the engine and thus an engine misfire will occur. When this happens, the ignition wires must be replaced to restore your vehicle’s ignition efficiency. The Mazda B2600 NGK ignition wire set ZE 17 is made to have good conductivity and provides OE fit for your Mazda model. Get it here!