Accel Point Set
If you want a guarantee that the ignition system of your vehicle will always be functional on the road, make sure that its parts are of good quality and well attended, the point set for instance. This particular ignition accessory is also known as the contact point, and it comprises one stationary and one movable metal contact surface. The parts are held in place in the distributor by small screws or clips and an anchor post. When the points are closed, the energy is stored in the primary windings of the coil. And when the points open, the energy is sent to the coil secondary windings and stepped up, resulting to a high voltage to fire the plugs. One of the products that you can rely on for your point set is the Accel point set. Now, proper attention should be extended to the part. Take note that older vehicles may be equipped with breaker point switching mechanisms - the point sets. And to inspect the mechanism, you have to remove the distributor cap and the rotor. You can check the points and the condenser to make sure that that they are securely fastened. Push the breaker points open with a screwdriver and check the condition of the contact surfaces. If you notice badly oxidized, blackened, or pitted points, then the said part should be replaced. Also do take note that the point set can get burned over time. This can cause intermittent misfiring that will not probably be easily noticed until there is a complete breakdown. And when that breakdown occurs, there is no other recourse but to replace the said part. This is how sensitive a point set is. Since everything depends on the ignition system and its components, make sure that a dependable part is used, like the Accel point set. Remember that a good ignition system is vital for the good health of your vehicle.
